jwildfire-forum.overwhale.com

The official JWildfire/Flamelet forum
It is currently Wed Dec 01, 2021 2:35 pm

All times are UTC+01:00




Post new topic Reply to topic  [1 post ] 
Author Message
PostPosted:Wed Apr 21, 2021 7:46 am 
Offline

Joined:Tue Nov 25, 2014 7:08 pm
Posts:47
author="Robert Keen" catagory="Randomizer"
info="Makes Interesting changes of the Yin Yang style. I wanted this to be a 3D style but was unable to re-create my original flame. However I left the post veriations zscale, zcone and colorscale in place. I set them hopefully in a way that will not produce streaks. Set your pitch between 5 - 45 degree. Then adjust zscale and / or colorscale between 0.1 to 0.5 to produce a z lift. Adjust up and down until you see the center streak line disapear. This is the trick of balancing the z factor in reguler flames. I also eliminated the DOT in the center by stting Anti Aliasing and amount to zero. You can always adjust up ; but you run the risk of the dreaded dot."

You can also change to different cuts on transform 3 for a different look.

Note - Specks will go away using the denoiser during a render.
You can increase the weight on transform 3 to bring out more detail on the cut variation.
You can also change to different cuts on transform 3 for a different look.


You do not have the required permissions to view the files attached to this post.


Top
   
Display posts from previous: Sort by 
Post new topic Reply to topic  [1 post ] 

All times are UTC+01:00


Who is online

Users browsing this forum: No registered users and 0 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited
Theme Created by HOLLYSMOKE
Theme updated to phpBB 3.1.6 by KamijouTouma
Theme Version is 3.1.6-ss2